标准属性

制定国家：英国
标准名称：《Flanges and their joints — Design rules for gasketed circular flange connections Part 2 Gasket parameters》英文版
文件大小：845KB
标准编号：BS EN 1591-2-2008

标准预览

1 Scope
This European Standard details generic gasket parameters for use in EN 1591-1 during preliminary calculations during which the type of gasket to be used in an application is to be decided. Once the gasket type has been decided the parameters for gaskets of that type from the different potential commercial suppliers should be used in further calculations as within a gasket type there will be differences depending upon the supplier.
WARNING — For the final calculations using the method given in EN 1591-1 the reader is directed to obtain gasket parameters for the selected generic type of gasket from the intended gasket manufacturer. This is because the data for a generic gasket type will vary between manufacturers.This variation can be seen in the tables of data which are embodied in this document.
2 Normative references
The following referenced documents are indispensable for the application of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
EN 1591-1:2001, Flanges and their joints — Design rules for gasketed circular flange connections — Part 1:Calculation method
EN 13555:2004, Flanges and their joints — Gasket parameters and test procedures relevant to the design rules for gasketed circular flange connections
3 Symbols and definitions
For the purposes of this document, the symbols and definitions given in EN 1591-1:2001 and EN 13555:2004 apply.
4 Typical gasket parameters for various gasket styles
4.1 General
It shall be noted that the data given in the following tables is only intended to be used in preliminary calculations using EN 1591-1. The data was obtained using the test methods given in EN 13555 during the testing of a selection of a few of the many styles and makes of commercial gasket that are on offer in Europe. For final calculations the user of EN 1591-1 shall contact the gasket supplier of choice and obtain the data for the style and thickness of the gasket intended to be used.
…………………………

声明：本站所有文章，如无特殊说明或标注，均为网友投稿，如若本站内容侵犯了原著者的合法权益，可联系我们进行处理。